MK2/2 – MK2/3 Magnet Bridging Sensor for security applications
These proximity switches operate when in the presence of magnetically conductive material. Instead of an actuating magnet, only a simple piece of iron is required to operate the switch – from the front or from above. These sensors are available as form A and form B switches. The standard cable is a 4 – wire round core 4 x 0.14 mm² (cable sheath and wires are white) forming a sabotage loop.
Door and window control
Opening recognition control
Fastening bolt control
Building BUS technology
Fire protection doors
Tolerance +/- 0.10mm (0.004 inch)
The standard termination is a four-wire UL-approved round cable with a cross section of 4 x 0.14mm²; white colored cable sheath and wires with integrated sabotage loop. The standard cable length is 500mm, other lengths can be supplied on request. The required length has to be stated in the part number. The cable end can be supplied with the following connection styles (please note after the length in the part number).
|W||Cable end cut, dismantled on 30 mm, cores stripped and tinned on 5 mm|
|Breakdown voltage (contact/contact)||min.||(VDC)||210||200|
|Operating time incl. bounce||(ms)||0.5||0.7|
Other switches by request.
|The switching distance can be decreased by mounting the MK2/2 on iron. When mounting the sensor, magnetically conductive screws must not be used.|
|MK2/2Operation from the front
|The MK2/3 must not be mounted on iron. When mounting the sensor, magnetically conductive screws must not be used.|
|MK2/3Operation from above
MK2/2 – 1A71 – 500 W
MK2/2 Reed Sensor, 1 form A switch type 71, Cable length 500mm, Termination W